jonas
New Member
Posts: 1
|
Post by jonas on May 10, 2021 3:59:36 GMT -5
Hi, I'm searching for a possibility to link power distributors to each other. Lets's say all my System is on one 125A CEE Power connector. (230V, typically in Europe) See the table understand my patch (shortened a bit in Multicable B, C & D): 125A CEE | X1 32 A CEE Out | -> | -> Dimmer A 12 Ch | -> | 12 Fresnel 1K | | X2 32 A CEE Out | -> | -> Dimmer B 12 Ch | -> | 6 S4 575W, 6 PAR 1K | | |
| -> Aux Hot Pocket L1 | -> | Fog machine | | X3 63 A CEE Out | ->63 A Power Distr. | -> MH Power 1 Distr. | -> Mulitcable A 6 Ch | -> MH Sharpy
|
|
| (splits up to 2x32A) |
|
| -> MH Sharpy
|
|
|
|
|
| -> MH Sharpy
|
|
|
|
|
| -> MH Sharpy
|
|
|
|
|
| -> MH Sharpy
|
|
|
|
|
| -> MH Sharpy
|
|
|
|
| -> Multicable B 6 Ch | -> 6 MH Sharpy | |
|
| -> MH Power 2 Distr. | -> Multicable C 6 Ch | -> 6 MH B-EYE K20 | | |
| | -> Multicable D 6 Ch | -> 6 MH B-EYE K20 |
|
|
|
| -> Aux Hot Pocket L3 | -> FOH Power |
I figured how to configure Dimmer A and B and both MH Power Distr., but is there a way to link them together so I can see the load of each phase in each stage of the setup? (In this specific case I want to know the loads of the "63A Power Distr.") I hope it's understandable with the table - if not I can also draw a short sketch. Thanks a lot! Jonas
|
|