|
|
Post by profpelican on Apr 29, 2021 11:13:13 GMT -5
Is there a reason why when I try to print out my break out sheets any fixture in a different system other then (A) will not print at all?
Thanks
cliff
|
|
|
|
Post by nik on May 2, 2021 12:53:21 GMT -5
Systems are essentially a way of putting two, or more, different shows into one Lightwright file. When you use systems it always separates Channel, Dimmer/Address, Circuit Name and Number by System. Traditionally it was used when the moving light rig and the conventional rig where being controlled by separate consoles. Using systems allowed you to have duplicate channels and addresses since each was unique to the console. I have also used it when the doing a corporate event spread across a couple of ballrooms, where each ballroom is essentially its own little world, but I want to be able to get totals and counts without doing math.
|
|
