|
|
Post by jeffmbike on Oct 19, 2016 10:49:05 GMT -5
Hello
I am using on of John's pre made labels but I cannot seem to get the dip switches to print out. I am using Martin Atomic Strobes and cannot figure out what I am doing wrong. I have added all the information in the maintaince list
Thanks
Jeff
|
|
|
|
Post by litedoctor on Oct 19, 2016 12:51:33 GMT -5
This is a tricky one. You have to create a User Column for the Dip Switches.
Use the Column Names & Definitions option under the Setup Menu. Use whichever User# you want. On the far Right side of that panel the last column is Data Type. Clicking there brings up a Pop Up menu, choose DIP Switch.
On your Labels, create a field which gets data from that Dip Switch column. On fixtures without DIPs, it will be invisible.
|
|
|
|
Post by jfreeman on Oct 19, 2016 13:08:40 GMT -5
1. In Instrument type maintenance make sure you have a dip switch type selected and attached to the fixture. (there are additional settings for which way the numbers go and up/on or down/on in this area)
2. In Labels you Dip switches are displayed only (I think) on Panels and drag and size on label. Select panel and then use dip switch in the data source
- Justin F
|
|
