|
Post by ghanthorn on Nov 24, 2018 21:46:06 GMT -5
Any recommendations for documenting 16 bit dimmers with Sensor racks where each dimmer uses 2 DMX Values (course and fine) ? (We do this due to a lot of very long fades so just going back to 8bit is not an option)
Right now all I am doing is off setting the DMX addresses for the 16 bit dimmers (our ML Power dimmers in switch mode only use 1 DMX address)
|
|
|
Post by strouse on Nov 26, 2018 15:33:50 GMT -5
In the details window of your dimmer rack the second column from the left is the address column. This is editable, if you select all of the cells in that column you can type in your start address+2 and it will space your addresses by 2. So if your rack starts at one you'll type in 1+2. Once that is done just link your dimmers to the addresses in the dimmer tab of the dimming and control window. Hopefully this helps you out.
|
|