Post by G on Apr 11, 2018 3:11:33 GMT -5
Hi
I am using lightwright for events, with non patchable dimmers and hot power distros. So all my phase balancing will be done on the breakouts.
Is there any easy way to auto balance the entire system? as i have broken my racks down, for a rack per a truss. So the rack is going by the truss and not by which distro it is connected to.
Also after doing this, i would like to label everything as follows.
Circuit Name Circuit
DIMA 1
DIMA 2
etc. etc.
Circuit Name Circuit
HP1 1
HP1 2
etc. etc.
Circuit Name Circuit
HP2 1
HP2 2
etc.
Is there a way for me to set lightwright up to do this automatically for me?
Many Thanks
I am using lightwright for events, with non patchable dimmers and hot power distros. So all my phase balancing will be done on the breakouts.
Is there any easy way to auto balance the entire system? as i have broken my racks down, for a rack per a truss. So the rack is going by the truss and not by which distro it is connected to.
Also after doing this, i would like to label everything as follows.
Circuit Name Circuit
DIMA 1
DIMA 2
etc. etc.
Circuit Name Circuit
HP1 1
HP1 2
etc. etc.
Circuit Name Circuit
HP2 1
HP2 2
etc.
Is there a way for me to set lightwright up to do this automatically for me?
Many Thanks